UCTRONICS ESP8266 Weather Station IoT Starter Kit for Arduino IDE with ESP8266 ESP-12E Development Board 0.96″ OLED Display and DHT11 Temperature and Humidity Sensor

Name: UCTRONICS ESP8266 Weather Station IoT Starter Kit
Specification:
ESP8266 ESP-12E Development Board
802.11 b/g/n protocol
Wi-Fi Direct (P2P), soft-AP
Integrated TCP/IP protocol stack
Integrated TR switch, balun, LNA, power amplifier and matching network
Integrated PLL, regulators, and power management units
+19.5dBm output power in 802.11b mode
Integrated temperature sensor
Supports antenna diversity
Power down leakage current of < 10uA
Integrated low power 32-bit CPU could be used as application processor
SDIO 2.0, SPI, UART
STBC, 1×1 MIMO, 2×1 MIMO
A-MPDU & A-MSDU aggregation & 0.4 s guard interval
Wake up and transmit packets in < 2ms
Standby power consumption of < 1.0mW (DTIM3)

0.96″ 128×64 pixel OLED display
Size: 0.96”
Resolution: 128X64
Supported platforms: for Arduino, ESP series, 51 series, MSP430 series, STIM32 / 2, SCR chips
Driver IC: SSD1306
Communication: IIC
VCC: 3.3~5V
GND: Ground
SCL: Serial Clock
SDA: Serial Data

DHT11 Temperature and Humidity Sensor
Digital signal output
VCC: 3.3V~5V
GND: Ground
DATA: MCU IO port
Tips: Do not reverse the VCC and GND, otherwise it will burn!

Package including:
1pcs ESP8266 ESP-12E Development Board
1pcs 0.96″ OLED display
1pcs DHT11 Temperature and Humidity Sensor
1pcs 40x10cm female-female jumpers
1pcs USB cable
The UCTRONICS ESP8266 Weather Station IoT Starter Kit includes an ESP8266 ESP-12E Development Board, a 0.96″ OLED display, a DHT11 Temperature and Humidity Sensor, 40x10cm female-female jumpers, a USB cable as well as a UCTRONICS user guide (link for download), the breadboard shown in the picture is not included
Developer-friendly module ESP8266 come with a USB connector and the maximum number of available pins. ESP8266 full IO mouth leads directly download without reset
The 0.96″ 128×64 pixel OLED display supports I2C, wide viewing angle, low power consumption and high response speed
DHT11 Temperature and Humidity Sensor with characteristics humidity measurement range: 20~90% RH, humidity measurement accuracy: +/-5% RH, temperature measurement range: 0~50°C, temperature measurement accuracy: +/-2°C
UCTRONICS ESP8266 Weather Station IoT Starter Kit gets the current and forecast weather information from an online service and displays the expected conditions on a 128X64 pixels OLED display with nice icons. The program uses a side scrolling carousel to display the date, time. In addition, it displays the information about 3-day forecast temperature and humidity through DHT11 sensor