Bottom Case Rubber Feet for MacBook Pro Retina A1425 A1502 A1398 13″ 15″

Warning:

1.Do not wipe the glue.use the cotton dry swab to absorb any excess glue.
2.Fumes from other types of glue could affect other internal components.Excess puddled glue may take hours to dry and may cause the bottom case to adhere to the logic board or interior cabling.

3.Screws at sides and front must be removed and installed at an angle.

4.Install screws in order shown. If sequence is not followed, bottom case might wobble when placed on level surface.

SAFETY INSTRUCTIONS-GLUE IS AN EYE AND SKIN IRRITANT.

GLUE BONDS TO SKIN INSTANTLY.

Contains ethyl cyanoacrylate. Avoid contact with skin and eyes. If eye or mouth contact occurs, hold eyelid or mouth open and rinse thoroughly but gently with water only for 15 minutes and GET MEDICAL ATTENTION. Liquid glue will sting eye temporarily. Solidified glue may irritate eye like a grain of sand and should be treated by an eye doctor.

If skin bonding occurs, soak in acetone-based nail polish remover or warm soapy water and carefully peel or roll skin apart (do not pull). Contact through clothing may cause skin burn. If spilled on clothing, flush with cold water. Avoid prolonged breathing of vapors. use with adequate ventilation. KEEP OUT OF THE REACH OF CHILDREN.

General information

1.A MacBook Pro covered by the Apple Limited Warranty or by an AppleCare Protection Plan may receive a replacement foot without charge.

2.A MacBook Pro that is out-of-warranty may have a charge associated with the replacement.

3.The DIY replacement kit not available for MacBook Pro OR Air computers.

4.Material

This set is not original. Please note it is harder than original one.

5.How to replace

https://support.apple.com/en-us/HT202450
Macbook pro retina rubber feet pad set include out feet and super glue. Anti-slip rubber feet is used for supporting the whole MBPR, with 3M self adhesive sticker. The adhesive pasted on adhesive rubber feet, is one kind of two sided sticky tape that comes off easily, super glue is necessary to stick them tightly.
Include: Macbook pro retina feet (Outer foot × 4),super glure × 1, screwdriver ×1
There are 3 types of macbook rubber pad, check serious No. at the bottom case before order.This kind of rubber feet are fit for macbook PRO Retina mac 13 mac 15 A1425 A1502 A1398 ONLY ,not for AIR ONES( A1370 A1369 A1465 A1466 ) PRO RETINA ONES(A1278 A1286 A1297)
Please note this rubber feet is not original.harder than original ones.It is better to replace all the feet when only one or two feet missing.
Convenience Packaging with tools, Easy replacement with Instruction